Tabla de contenido
Idiomas disponibles
Idiomas disponibles
User's instructions, Kids trimmer set
DLD404
Figure 3
Fitting comb attachments
Note
We recommend that you use the largest comb attachment when becoming
familiar with the appliance. You can always switch to a smaller comb
attachment if you think that your hair is still too long.
Cutting
1.
Fit the required comb attachment to the trimmer. You can also use the trimmer
without a comb attachment; you can then cut your hair to any required length.
2.
Switch on the trimmer by setting the On/Off switch to 1 (On).
3.
Start cutting your hair. Move the trimmer at an angle to your skin to remove
unwanted hairs.
4.
After use, switch off the appliance by setting the On/Off switch to 0 (Off).
Neck
5.
Fit the required comb attachment, for example comb 1 (3 mm or 6 mm).
6.
Keep the cutting comb face upwards, and trim the hair in your neck from the
bottom.
7.
Trim the hair in successive widths, and from bottom to top.
8.
Move the trimmer slowly so that the cutting comb trims all the hair. Slow trimming
gives the best result.
Back of the head
9.
Fit the required comb attachment, for example comb 2 (9 mm or 12 mm).
10. Trim the hair on the back of the head by slowly moving the trimmer from the
bottom to the top, against the direction of growth.
Sides
11. Fit the required comb attachment, for example comb 1 (3 mm or 6 mm) and trim
the hair on the temples.
12. Use a short comb attachment for sideburns. Move the trimmer from top to bottom,
with the cutting comb facing downwards.
Top of the head (crown)
13. Fit a large comb attachment, for example comb 2 (9 mm or 12 mm). Obviously
you can always use a smaller comb attachment if you require shorter hair.
14. Trim the top of the head by moving the trimmer from the back to the front, against
the direction of growth.
15. When the hair on the top of the head is very long you can use the comb to lift the
hair whilst you use the trimmer to trim the hair above the comb.
EN
v 091019-05
25
Tabla de contenido
