Assembly Of Scoreboard - Favero Electronics FC Serie Manual De Instalacion Y Uso

E NG LISH
following two conditions: (1) this device may not cause interference, and (2) this device must accept any
interference, including interference that may cause undesired operation of the device. Under Industry
Canada regulations, this radio transmitter may only operate using an antenna of a type and maximum (or
lesser) gain approved for the transmitter by Industry Canada. To reduce potential radio interference to
other users, the antenna type and its gain should be so chosen that the equivalent isotropically radiated
power (e.i.r.p.) is not more than that necessary for successful communication.

4. Assembly of scoreboard

To ensure fast and affordable shipping, the various modules of the scoreboard are separated before
shipping. These modules must be assembled before installation.
Extract all the modules from their packagings. Each module is identified with a label on its back
indicating to which panel it belongs: central panel (CENTER), left panel (LEFT) or right panel (RIGHT). The
label indicates also the assembling position (1, 2, 3, ...), where no. 1 refers to the upper position.
To avoid injuries such as bruises, scrapes, or cuts while handling the scoreboards, we advise
wearing protective gloves and safety shoes.
4.1. Joining the modules by means of brackets
Assemble the scoreboard on the floor before mounting it on the wall. Follow the directions below:
1. Make sure you have all the necessary pieces: modules for putting together the scoreboard (see the
various modules on pages
2. We suggest placing protective material such as cardboard on the floor to serve as a base for
assembling the board. Place the modules face down on the floor and in numerical order from top to
bottom (Fig. 1), in order to assemble the desired panel.
3. Position the two brackets on the modules of each scoreboard's panel (central, left, right). Align the
fixing holes and firmly lock the brackets using the screw provided. The bracket's oval holes for fixing
the scoreboard must face the inner side of each panel
1. Module identification number.
2. Power supply cable.
Fixing of the support brackets.
Fig. 1
8
/ 94
2 and 4), brackets and screws for attaching the brackets to the modules.
00304-M02-03 - ML-FC serie scoreboards - User Manual Rev03 - 160826 -
(Fig. 2).
3. Cables directed to the other modules.
4. Fixing eyelet.
FAV E RO E L EC T RO NIC S