Risco VUpoint RVCM32W Guia De Instalacion página 11

Step Description

If you run the cable from the top of the installation surface, make an exit hole
on the installation surface according to the installation positioning template.

If you run the cable from the side of the cable channel, it must go through the
U-shaped channel on the dome support. Take out the cable from the side of the
exit hole located on the support.
7 Adjust the device installation support to the proper position and then run the cable
through the exit hole located on the installation surface.
8 Align the TOP mark on the device installation support with that of the installation
template.
9 Align the three screw holes in the device support with the three plastic expansion
bolt holes in the installation template.
10 Firmly affix the three self-tapping screws to the three plastic expansion bolts.
11 Secure the dome body to the installation surface.
12 Hold both sides of the base of the rotation bracket, rotate horizontally along the
axis and adjust the lens in the horizontal direction to the designated position.
13 Hold the LED cover and rotate it vertically while adjusting the lens in the vertical
direction to the designated position.
If too tight to adjust, first loosen the fixed screws on both sides of the bracket (do not
remove the fixed screws), then adjust the lens and tighten again the fixed screws.
14
While holding the LED cover, rotate it along the axis and adjust the lens image to
the correct surveillance position.
Range of lens:

vertical (0°～+64°)

horizontal (0°～+355°)

image rotation direction (0°～+355°)
NOTE – When rotation is at 64° in the vertical direction, please pay attention to the
image rotation direction in order to prevent blockage of the IR light by the outer
cover, as this can negatively influence the IR effect.
9