Programming - Locinox SlimStone Manual De Instrucciones

6.

PROGRAMMING

6.1 ACCESS PROGRAMMING MODE
• Press # for 5 sec, after the LEDs will flash.
• Enter the Master PIN (see 6.3) and press
# . If correct, # will remain lit as long as
the programming mode is activated. When a
wrong code is entered, all keys will flash.
If only # is lit, you are in the main menu
of the programming mode.
• Select a menu number (see 6.2) and confirm
with # .
The programming mode ends
automatically when there is no activity
for 60 seconds.
C
• Press to move up one menu.
• If a wrong Master PIN is entered, the
programming mode ends and the time out
procedure as described in 5.2 applies.
• Press C for 5 seconds to exit the
programming mode.
6.2 OVERVIEW
9  set a Master PIN
1  add a PIN code
2  delete a PIN code
3  set hold time
4  set lighting mode
0  factory reset
6.3 SET MASTER PIN
• Access programming mode (see 6.1).
For safety reasons we strongly recommend
to change the Master PIN upon first use.
• Press 9 and confirm with
9 #
• and are both lit.
The default Master PIN is 12345. It always
has to be a 5-digit code.
• Enter a new 5-digit Master PIN and press
# . Repeat this step.
• If both codes are equal, all LEDs will light
briefly and you will return to the main menu
of the programming mode.
SlimStone
• For safety reasons, the Master PIN can
6.4 ADD A PIN CODE
• Access programming mode (see 6.1).
• Press
•
• Enter a new PIN code and confirm with
• If both codes are equal, the new PIN code is
• You will return to the main menu of the
6.5 REMOVE PIN CODE
• Access programming mode (see 6.1).
• Press
•
• Press the PIN code you wish to delete and
• All LEDs are briefly lit, indicating the code is
• You will return to the main menu of the
# .
When two different codes or a wrong code
length is entered, all LEDs will flash three
times, indicating the code hasn't been
9
saved. Try again.
only be entered to access the programming
mode. It cannot be used as an entry code.
A maximum of 100 different PIN codes
can be programmed (min. 4 - max. 8
digits).
1 and confirm with
1 and # are both lit.
Repeat this step.
saved. All LEDs will light briefly.
programming mode.
When two different codes or a wrong code
length is entered, all keys will flash three
times, indicating the code setting hasn't
been saved. Try again.
2 and confirm with
2 and # are both lit.
press C . Repeat this step.
deleted.
programming mode.
When two different codes or a wrong code
length is entered, all keys will flash three
times, indicating the code wasn't deleted.
Try again. 2 will remain lit.
will remain lit.
# .
# .
1
will remain lit.
# .
11
EN