Disposal Of Used Machine - Chicago Pneumatic WAP 2 Instrucciones De Seguridad Y De Funcionamiento

WAP 2, WAP 3
Note! Maintenance must only be done by
suitably qualified and competent persons.
Before doing any maintenance, make sure
that the machine is safe and correctly sited
on the ground.
Daily
The daily maintenance of the submersible pump
and the quick-release couplings is confined to
cleaning after use.
Check the hoses regularly for damage. Replace

if necessary.
Clean the quick-release couplings before use.

Use this maintenance schedule to maximize
service life.
Monthly
Inspect the hydraulic hoses and fittings

thoroughly.
WAP 3 pump only: Remove and clean the base

legs and base plate. Remove any material that
may have accumulated near the inlet port.
Recommended hydraulic oil
In order to protect the environment, Chicago
Pneumatic recommends the use of biologically
degradable hydraulic oil.
Viscosity (preferred) 20-40 cSt.

Viscosity (permitted) 15-100 cSt.

Viscosity index Min. 100.

Standard mineral or synthetic oil can also be used.
The pump shall not be used, if oil viscosity fails to
remain within the permitted area, or if the working
temperature of the oil does not fall between -20°C
(-4°F) and 70°C (158°F).
3392 5187 83
Safety and operating instructions

Disposal of used machine

A used machine must be treated and disposed of
in such a way that the greatest possible portion
of the material can be recycled and any negative
influence on the environment is kept as low as
possible.
Note! Before a used machine is scrapped, it must
be emptied and cleaned from all hydraulic
oil. Remaining hydraulic oil must be
deposited in a responsible manner.
11