Reset To Factory Settings - GE 24991 Manual De Instrucciones

Master Volume Feature, cont.
3. Press and release the
4. Press and release the VOL - button.
To make sure the Master Volume Feature
is disabled, put the remote in TV mode if
you programmed the cable box to be the
Master Volume Device. Point the remote
at the TV and press a volume button.
If the volume changes on the TV, the
feature is disabled. If the volume on the
cable box changes, and not the TV, you
will have to repeat the steps above and
test again.

Reset to Factory Settings

1. Press and hold the SETUP button
2. Press and release the OK button.
3. Press and release the number #0
MUTE button.
The red indicator light
will blink twice and go off.
until the red indicator stays on
(approximately 2 seconds) and then
release the button.
button. The red indicator light will
flash twice.
12