VALERA Turbo Style 1000 Tourmaline Instructions For Use página 4

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 19
•Do not try to pull any electrical appliance out when
it has fallen into water - disconnect the plug from
the power socket immediately.
•Always switch off the unit before putting it down.
•After use always switch the unit off and remove the
plug from the power supply socket. Do not pull on
the wire to remove the plug from the power supply
socket.
•Do not pull the plug out of the power supply socket
when your hands are wet.
•When using the appliance make sure the air intake
and exhaust grilles are never obstructed. This unit
is fitted with a device to guard against overheating
that switches it off immediately when the
temperature gets too high. Should this happen,
move the switch to the 0 position and leave it to
cool for 5 minutes.
•Always allow the unit to cool before putting it away
and never wrap the cord around the unit.
•Check that the cord has not been damaged from
time to time.
•Do not use your unit if it is not working properly, if
it has fallen or if the cord is damaged. Do not try to
repair this electrical unit yourself, rather contact an
authorized technician.
•The elements used to pack the unit (plastic bags,
cardboard box, etc.) must be kept out of reach of
children as they are a potential danger to them.
•This unit must only be used for the purposes for
which it is expressly intended. Any other use is to
be considered improper and therefore dangerous.
The manufacturer accepts no responsibility for
damage caused by improper or erroneous use.
•Do not use hair spray while the unit is running.
•To avoid dangerous overheating, it is advisable to
unwind the entire length of the cord.
•Warning - The metal parts overheat if used for too
long. Be careful and allow these parts to cool before
touching them.
Important
This hairdryer conforms to the safety regulations regarding electrical appliances.
This hairdryer has a safety cut-out which will operate in case of overheating. The dryer
will re-set itself after being left to cool for a few minutes, but please check air inlet and
outlet grills are clear before continuing to use the dryer.
4
Tabla de contenido
loading

Este manual también es adecuado para:

603.01

Tabla de contenido