Using The Wall-Mounted Door Control; To Open The Door Manually - Craftsman 139.53993DM Manual Del Propietário

Using the Wall-Mounted Door Control

THE PREMIUM CONTROL CONSOLE
Press the lighted push button to open or close
the door. Press again to reverse the door
during the closing cycle or to stop the door
while it's opening.
Light feature
Press the Light button to turn the opener
light on or off. It will not control the opener
lights when the door is in motion. If you
turn it on and then activate the opener, the light will remain on
for 4-1/2 minutes. Press again to turn it off sooner. The 4-1/2
minute interval can be changed to 1-1/2, 2-1/2, or 3-1/2 minutes
as follows: Press and hold the Lock button until the light blinks
(about 10 seconds). A single blink indicates that the timer is reset
to 1-1/2 minutes. Repeat the procedure and the light will blink
twice, resetting the timer to 2-1/2 minutes. Repeat again for a
3-1/2 minute interval, etc., up to a maximum of four blinks and
4-1/2 minutes.
Lock feature
Designed to prevent operation of the door from hand-held
remote controls. However, the door will open and close from
the Door Control, the Outdoor Key Switch and the Keyless Entry
Accessories.
To activate, press and hold the Lock button for 2 seconds. The
push button light will fl ash as long as the Lock feature is on.
To turn off, press and hold the Lock button again for 2 seconds.
The push button light will stop fl ashing. The Lock feature will also
turn off whenever the "learn" button on the motor unit panel is
activated.
Additional feature when used with the 3-Function hand-held
remote control
To control the opener lights:
In addition to operating the door, you may
program the remote control to operate the
lights.
1. With the door closed, press and hold a small remote control
button that you want to control the light.
2. Press and hold the Light button on the door control.
3. While holding the Light button, press and hold the Lock button
on the door control.
4. After the opener lights fl ash, release all buttons.

To Open the Door Manually

Lighted
Push Button
To prevent possible SERIOUS INJURY or DEATH from a falling
garage door:
Light
• If possible, use emergency release handle to disengage
Button
trolley ONLY when garage door is CLOSED. Weak or broken
Lock
springs or unbalanced door could result in an open door
Button
falling rapidly and/or unexpectedly.
• NEVER use emergency release handle unless garage
doorway is clear of persons and obstructions.
• NEVER use handle to pull door open or closed. If rope knot
becomes untied, you could fall.
DISCONNECT THE TROLLEY:
The door should be fully closed
if possible. Pull down on the
emergency release handle (so
that the trolley release arm
snaps into a vertical position)
and lift the door manually.
The lockout feature prevents
the trolley from reconnecting
automatically, and the door can
be raised and lowered manually as
often as necessary.
TO RE-CONNECT THE TROLLEY:
Pull the emergency release
handle toward the opener at an
angle so that the trolley release
arm is horizontal. The trolley
will reconnect on the next UP or
DOWN operation, either manually
or by using the door control or
remote control.
31
Trolley
Trolley Release
Arm (in Manual
Disconnect Position)
Lockout position
(Manual disconnect)
Trolley
Trolley
Release
Arm
Emergency
Release Handle
(Pull at 45° angle)
To reconnect