Maintenance - ArmorAll VAC-MATE AA155 Manual Del Usuario

IMPORTANT!
When vacuuming large quantities of liquids, do not immerse the nozzle completely in the
liquid; leave a gap at the tip of the nozzle opening to allow air inflow. The machine is fitted with a float valve
that stops the suction action when the container reaches its maximum capacity. You will notice an increase
in motor speed. When this happens, turn off the machine, disconnect from power supply, and drain the
liquid into a suitable receptacle or drain. To continue vacuuming, refit the container with the drain cap.
After wet vacuuming, turn the machine off and remove plug from power supply. Empty the container, clean
and dry the inside and outside before storage.
REMEMBER!
The foam filter must be removed after wet vacuuming, and a reusable cloth filter must be
installed before dry vacuuming again.
MAINTENANCE & FILTER CLEANING
1. Verify that the power cord is disconnected from the outlet. (fig.1)
2. Disconnect the hose from the vacuum. (fig.2)
3. Undo the latches and remove the power head from the container. (fig.3 & 4)
4. Clear all dirt or debris from the container and hose. (fig.5)
For filter changing and maintenance see instructions on page 10.
IMPORTANT!
Clean or change the dust filter regularly for best performance. ALWAYS USE DUST
FILTER FOR DRY VACUUMING. If the machine is used without the dust filter, the motor will burn out and
the warranty will be voided. Always keep spare filters on-hand.
NOTICE!
The filter included is made of high quality material designed to stop small dust particles. The
filter should be used for dry pick-up only. A dry filter is necessary to pick up dust. If the dust filter is wet, it
will clog quickly and be very difficult to clean. Handle the filter carefully when removing it for cleaning and
replacing it. Check the filters for tears or small holes, a small hole can let dust pass through and out of the
cleaner. Do not use a filter with holes or tears in it. Replace the filter immediately if it has a tear or hole.
WARNING:
ALWAYS DISCONNECT THE PLUG FROM THE POWER OUTLET BEFORE REMOVING
THE POWER HEAD FROM CONTAINER.
9