Fitting The Gate - GI.BI.DI. Ground Serie Instrucciones De Instalación

GROUND
EMBEDDING THE OPERATOR BOX
Listed below are some typical conditions in which you might be operating with the relative suggestions for each one of
them 6 - 7 - 8 - 9 :
[ ] [ ] [ ] [ ]
a) Gate still to be installed:
- It is preferable to fit an adjustable type upper hinge for the leaf.
b) Gate with adjustable hinges:
- Remove the lower hinge
- Loosen the upper hinge and turn the leaf 6
- Embed the box
- Refit the leaf
c) Gate with fixed hinges:
- Remove the gate
- Remove the lower hinge
If the gate cannot be removed, insert a support shim underneath the lower edge of the leaf.
FOUNDATION EXCAVATION
• Dig a foundation hole with the dimensions indicated in 7 .
NOTE: Depending on the type of ground, it is advisable to make a foundation for casting of quick-drying cement.
• Position the operator box in the excavation respecting the indications in 8 and check that it is level.
CAUTION: Make sure that the centre of the operator pin is perfectly in line with the hinge of the gate leaf 2b - 3 .
• Arrange a PVC tube of at least 35 mm diameter up to the operator cable inlet through which to run the electric
[ ]
cables 9 . Provide for a rainwater drain pipe, preferably connected to a water recovery duct 9 .
• Embed the operator box in the foundation hole..

FITTING THE GATE

N.B. Check that the cement in the foundation hole has dried sufficiently before installing the operator.
1) Fit the lever unit to the box pin 10 ;
MODO 1:
2) Procure a U-bracket with the dimensions indicated in 11 ;
3) Weld the U-bracket on the operator support arm 12 ;
4) Position the gate in the guide bracket and hinge it in the upper part;
5) Check that the gate is on bubble;
6) Close the U-bracket on the pillar side with a plate 13 .
MODO 2:
2) Weld the leaf directly on the gate support arm 14 checking that it is on bubble 14 .
[ ]
[ ]
[ ]
[
[ ]
[ ]
[ ],
[ ]
]
[
[ ] [ ]
[ ]
]
21