SBS TECLIPHEADSETBTK Manual De Instrucciones página 4

UK
INSTRUCTIONS
Before to start remember to charge your device using the USB -
micro USB cable supplied.
1 Power: Press the multifunction button 3 seconds, the blue LED
will flash 3 times and you will hear a beep.
2 Power off: in standby mode, press and hold the multifunction key
until the red LED blinks once and you will hear a beep.
3 Bind: with device off, press the multifunction key about 7seconds,
until the blue and red LEDs flash alternately. Turn on Bluetooth on
your device and set research: when devices are connected to the
earpiece, will emit a beep.
4 Response to a Call (with your connected phone): press the
multifunction button once, the headset beeps.
5 Hold a call: during the call, press the multifunction button once
until the earpiece will emit a signal.
6 Rejecting a call: press about 2 seconds, the multifunction button
will emit a signal.
7 Ending a call: during the call, press the multifunction button.
8 Adjusting the volume: Press (+) to increase, (-) button to zoom
out.
9 Recall last number: press the multifunction key twice, the
headset will beep.
10 Voice dialing: in standby mode, press and hold the (+) (-) at the
same time, you can voice dialing (only for phones that support
this feature).
11 Change the conversation from phone to headset: During a call,
press the multifunction button about 2 seconds: the conversation
will switch to the phone; press again about 2 seconds, the call
will return to the headset.
12 Microphone mute: on line, press (+) (-) about 2 seconds, the
LED will flash blue and red 2 times, the earpiece will emit a
signal.
13 After 10 minutes without connection, the headset switches off.
SAFETY IN CHARGE OF THE BATTERY LITHIUM POLYMER
• The headset is equipped with non-removable batteries lithium
polymer.
• Do not remove the batteries. Do not throw the earbuds in fire,
batteries may explode.
• Remove the batteries lithium polymer following the laws for
disposal of batteries in force in your country.
• Do not follow the advice for the use of batteries can produce fire,
explosion, fire, chemical.
• Do not allow battery fluid to get in contact with eyes or skin. In
case of contact, wash with plenty of water and seek medical advice.
• Do not expose the lithium polymer batteries at temperatures
above 60°.
• Do not disassemble, destroy, or short-circuit: can cause fire,
injury, or other hazards.
4