Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Mounting Installation Plate
Ensure that the wall is strong enough to withstand the weight
of the unit. Otherwise, it is necessary to reinforce the wall
with plates, beams or pillars.
Use the level gauge for horizontal mounting, and fi x it with
5 suitable screws for FTXK/FTKK 09/12 and 7 suitable
screws for FTXK/FTKK 18/24.
In case the rear piping draws out, drill a hole 2-9/16" (65mm)
in diameter with a cone drill, slightly lower on the outside
wall (see fi gure).
FTXK/FTKK 09/12
Mounting plate
fi xing screw
FTXK/FTKK 18/24
Mounting plate
fi xing screw
Drilling a Wall Hole and Installing Wall Embedded
Pipe
Hole with Cone Drill
Inside
Wall embedded pipe
(Field supply)
Wall- mounting
frame
Mounting plate
Mounting plate
Outside
Caulking
Ø 2-9/16" (65mm)
Wall embedded pipe
(Field supply)
Mount The Unit Onto The Installation Plate
Hook the indoor unit onto the upper portion of the installation
plate (Engage the two hooks at the rear top of the indoor unit
with the upper edge of the installation plate). Ensure that the
hooks are properly seated on the installation plate by moving
it to the left and right.
How To Attach The Indoor Unit
Hook the claws of the bottom frame to the mounting plate.
How To Remove The Indoor Unit
Push up the marked area (at the lower part of the front
grille) to release the claws.
Front grille
When stripping the ends
of interconnecting wires in
advance, bind right ends of
wires with insulating tape.
Wire guide
Water Drainage Piping
The indoor drain pipe must be in a downward gradient for
smooth drainage. Avoid situations that are likely to cause
water to leak.
Water Drainage
Water
Water
leaking
leaking
Correct
Wrong
CAUTION
• Do not install the unit at altitude over 6560ft (2000m)
for both indoor & outdoor.
1-11
Mounting plate
Clip
Bottom frame
Mark (Rear side)
Hand indoor unit's hook here.
Mounting plate
Interconnecting
wires
Water
retention
End
dipped
Water
into
leaking
water
Wrong
Wrong
Drain
Tabla de contenido
