NODOR V24B Manual De Instrucciones página 28

Built-in Cabinet Instructions
This unit is designed for both built-in or free standing
installation. If you plan to use this unit in a built-in
application please follow the requirements shown to
the below.
Cabinet Opening Dimensions
Width
Depth
Height
Figure 1
Figure 3
1.
Lock Screws
2.
Right Lower Hinge
3.
Door Shaft Assembly
4.
Right Top Hinge
5.
Door
6.
Cabinet
300 mm
600 mm
875 mm
Figure 2
Figure 4
7.
Left Top Hinge
8.
Left Lower Hinge
Installing the Handle
Gasket
Flat Washer
Lock Washer
Screw
1. Remove the door gasket on the side you wish
to install the handle - you can see two
designated holes for handle installation.
2. Install the handle tightly as shown above with
two screws, lock washers and flat washers provided.
1. Open the glass door and remove the two
screws under the right bottom corner of the
glass door that are used to hold the right lower
hinge to the door shaft assembly. Be careful to
support the glass door with hands to prevent it
dropping after removing the screws. (Figure 1)
2. Pull down to remove the glass door and place
it on a padded surface to prevent scratching it.
(Figure 2)
3. Remove the right top hinge and right lower
hinge. (Figure 3). Remove the left top hinge
and left lower hinge from the plastic bag that
includes the instruction manual then install
them at the designated positions at the left
side of cabinet. (Figure 4)
4. Turn around the glass door 180° and reinstall it.
Handle
Door
Frame