Speed Adjustment - GBC HeatSeal H800 Pro-R Manual De Operación

Tabla de contenido
SAFETY SHIELD LATCH
VERROU D'ÉCRAN DE SÉCURITÉ
SUJETADOR DE SEGURIDAD
FEED GUIDE
GUIDE D'ALIMENTATION
GUÍA DE ALIMENTACIÓN
FEED TABLE
PLATEAU D'ALIMENTATION
TABLA DE ALIMENTACIÓN
FEED TABLE LATCH
VERROU DE PLATEAU
D'ALIMENTATION
SUJETADOR DE LA TABLA
DE ALIMENTACIÓN
Gloss side against
Heat Shoes
Côté brillant contre les
rouleaux chauffants
Lado brillante contra las
cubiertas de calentamiento
Gloss side against Heat Shoes
Côté brillant contre les rouleaux chauffants
Lado brillante contra las cubiertas de calentamiento
ADHESIVE
SURFACE
SURFACE
ADH SIVE
POLYESTER
SURFACE DE
SURFACE
POLYESTER
12
Figure 8
SUPERFICIE
ADHESIVA
SUPERFICIE DE
POLIESTER
Figure 9
FILM LOADING & THREADING
Refer to Figure 8 or the film threading diagram on the feed table
of the laminator for illustration of properly loaded film.

SPEED ADJUSTMENT

Good, consistent lamination is a result of combining proper heat,
tension and dwell time. Dwell time is the amount of time the
material to be laminated is compressed between the rollers
and is control by the speed control.
As a general rule thicker items and film as well as dark or full ink
coverage items need to run at slower speeds. These items tend
to extract more heat from the heat shoe at a quicker rate. Thinner
items such as copy paper or tissue paper extract less heat from
the heat shoe and can be run at faster speeds
Do not combine thick and thin items at the same time as this will
result in a poor edge seal around the thicker material. If you are
unsure that the laminator is set at the proper speed for your item,
run a test piece (scrap) of the same or similar material through
the laminator. Make speed adjustments as necessary.
The following chart provides general guidelines for proper
speed settings to use on certain materials and laminating film
combinations. This chart is only a general guide.You may
have to adjust the speed depending on the actual media
being laminated.
LAMINATION GUIDE
Material
Newspaper
20 lb. Copier
Paper
Magazine Stock
Tissue Stock
Construction
Paper
Posters
Index Cards
File Folders
Poster Boards
Film Thickness
1.5 Mil
3.0 Mil
(.0015")
(.0030")
8 - 10
3 - 4
5 - 7
1 - 3
3 - 4
1 - 2
Tabla de contenido
loading

Tabla de contenido