Sinmag Europe DIVOBUN 3-30 Manual De Instrucciones página 22

Every 3 months
Tightening of V-Belts should be done from time to time when machine slows down.
ENG
Grease the nipples on both sides of the dividing head with grease gun.
6. TROUBLE SHOOTING
The machine does not start
• Electric phases are wrong.
The dough pieces are damaged
• The chamber height is to low.
• The dividing head contains old dough residues or are not clean.
Bad rounding result
• One of the springs under the rounding table is broken or worn out.
• The chamber height is not set accordingly to dough weight.
• Increase/decrease rounding time.
• Check if the dough weight is in accordance with the type of dividing head.
• The machine has not been cleaned and contains old dough residues.
Unequal dough weight pieces
• Dough must be placed in the center of the moulding plate, egalize dough evenly on the
moulding plate. The dough must not exceed the circles on the moulding plate.
• Increase pressing time.
The dough is squeezed between dough ring and moulding plate.
• The dough is pressed to much.
The chamber height is to low.
22