How To Use Your Me System - Elos me Guia Del Usuario

how to use your
1
4
6
8
Note: Start with LOW
the level for better results
11 EN
system
setting me up
1. Clean the cartridge light output window with a
non-alcohol based wet wipe or soft tissue. This is done
in order to remove hairs and dust from the treatment
window.
2. Connect the power cord into the
3. Place the
system on a table or area near an
electrical wall outlet. Move away any liquids from the
area.
4. Make sure the applicator is placed in its cradle before
turning on the .
5. Connect the power cord to the wall electrical outlet.
6. Press the power button to turn the system on. Wait until
the indicator light on the power button turns green.
Now the system is ready for use.
7. Set the desired energy level Low, Medium or High.
8. The cartridge is pre-loaded with pulses for your use.
When the Empty indicator starts blinking, it means
that there are only limited pulses left in your cartridge
and you should prepare a new one. When the Empty
indicator is on, you should replace your cartridge.
level, if you feel comfortable, you may increase
system.