Charging Battery; Transferring Files - Zipy Fun University Manual De Usuario

Rear View
k
l
j
The device has a built-in rechargeable battery. No extra battery installation is required.
Just charge the device when it indicates low battery.
You are strongly recommended to charge the battery immediately when the
device indicates the battery is lower than 15%!
To charge the battery, connect the device to any standard wall outlet via the DC-IN
port through the power adaptor. It takes about 5 hours to fully charge the battery.
Note:
a. You can operate the device even when it is being charged. But for extended battery life, it is
suggested NOT to use the device when it is charging.
b. It is recommended to charge the battery before you use the device for the first time.
c. For maximum performance, lithium-ion batteries need to be used often. If you don' t use the
device often, be sure to recharge the battery at least once per month.
Before reading or playing files, you need to transfer media files from a computer to the
device.
(1) Connect the device to a computer with the supplied USB cable.
(2) Once connected, two removable disk drives will show on your computer. One
represents the internal memory of the device, and the other represents the memory
card inserted into the device. Now you can copy files from or to these disk drives
just as you would on your hard drive.
(3) Once the data transfer completes, drag from the top bar downwards to display the
USB notification message as shown.
(4) Choose " Turn off USB Storage"and then tap " Turn Off"to disconnect the device
from computer.
j.Ultrasound and Infrared Sensor – capture
handwritten notes or drawings.
k.Reset pin hole – reset your device if the device
freezes.
l.SD Card Slot – accommodates SD memory
card.
m.Earphone
earphones.
m

Charging Battery

Transferring Files

Drag downwards
Port –
6
connects to stereo