Charging The Battery; Using The Device; Cleaning And Care - Clatronic EZ 2693 Instrucciones De Servicio

4....-05-EZ 2693
1. Connect the charging device to a 230 volt, 50 hertz socket.
2. Attach the motor housing to the charging pin.
1. Push a brush on to the drive rod. The bristles must point in the direction of the
switch. It must not be possible to turn the brush shaft in this position. The brus-
hes are fitted with different coloured rings so that they can be distinguished from
one another.
2. Rinse out your mouth thoroughly and moisten the bristles. You can use toothpa-
ste if required. In order to avoid splashes, switch the toothbrush on and off while
it is in the mouth.
3. Switch the toothbrush on by the switch (6).
4. Move the brush slowly in small circular movements and with a slight pressure
from tooth to tooth. It is not necessary to press hard. Take care that the head of
the brush also reaches the spaces between the teeth.
5. Rinse your mouth out after use. Pull off the head of the brush and clean it with
water. The brush head can be replaced in the container for storage.
6. The toothbrush is switched off by pressing the switch (6) again.
Note: During the first days of use it may be that bleeding of the gums occurs. This
normally stops after a few days. If the bleeding of the gums does not stop after 2
weeks, please consult a dentist.
• Pull down the brush head. Do not push down the brush but only the lower part
of the accessory (colored marking) and clean it under running water! Do not
use any additives to clean the head of the brush!
• The toothbrush is watertight and can be cleaned under running water! Please
do not immerse completely in water.
• Do not use any abrasive substances for cleaning! These may damage the seals
and the housing!
• Simple soapy water may be used to clean the toothbrush.
• Please note that toothbrushes lose their cleaning capacity after approx. 8
weeks. The spare brushes for your electrical toothbrush can be ordered at the
telephone specified in the „Service" section.
This device has been tested according to all relevant current CE guidelines,
such as electromagnetic compatibility and low voltage directives, and has been
constructed in accordance with the latest safety regulations.
Subject to technical changes without prior notice!
11.06.2002 8:55 Uhr

Charging the Battery

Using the Device

Cleaning and Care

Seite 23
GB
23