Wiring Diagram - Base Camp XB13 Manual De Instrucciones

3. Connect to the power inlet socket at the rear of the appliance
and the battery Indicator LED will stay a steady "RED" confirm-
ing that the battery is now charging. Once the unit is fully
charged the battery Indicator LED will change to "Green".
.
4. AC: Connect the three (3) pin plug to a suitable outlet then
connect to the appliance & switch on the AC outlet.
before allowing the battery to fully charge for 24 hours might
result in diminished battery life between charges.
• Charge time from either power source is 4 hours, 50% battery
capacity can be reached after 2 hours however to maintain
battery life & condition it is recommended that the unit is
allowed to charge for the full 4 hours.
• IMPORTANT – If the appliance is not being used or is stored
it must be recharged every three months to guarantee the
battery life expectancy, failure to do so may result in
battery failure.

WIRING DIAGRAM

CAUTION: Label all wires prior to disconnecting when servicing controls. Wiring errors can cause improper and dangerous operation.
The parts lists and wiring diagram show the appliance as it was constructed. Do not use a heater which is different from that
shown. Service should be done by qualified service technician.
AC INPUT
PUMP INPUT
• DO NOT USE – AC to DC
converters or modify the adaptors
supplied with the appliance.
• Before operating your new BOSS
shower for the first time, please
charge your unit for a full 24
hours to ensure that the
contained battery has a chance to
fully charge. Operating your unit
Basecamp, Inc. | Portable Shower
MAINTENANCE
WARNING: To prevent personal injury unplug the appliance from
any electrical outlets.
STORING
1. Press the "Power" button & turn the
appliance off.
2. Disconnect all hoses and hold vertically allowing all excess
water to drain from them. With the shower head check that
the flow regulation switch is in the
"ON" position.
3. Return the tap to its locked position if
being used.
4. Unscrew the LP cylinder from the appliance
5. Unscrew the drain plug which is located on the underside
towards the pump inlet connection then tip the appliance
towards the back and to one side to drain excess water from
the heat exchanger via the water inlet.
Using warm soapy water with a mild detergent wipe down all sur-
faces and areas of the appliance. DO NOT submerge the appliance
in a sink or bowl. DO NOT use abrasive cleaners or bleach. DO
NOT run soapy water through the heat exchanger.
MODEL:
XB13
6
Operating Instructions and Owner's Manual