Instructions For Installation - Gabarron TBB 8i Instrucciones De Instalacion Y Uso

EN
1. IMPORTANT INFORMATION

The warranty of the towel rail will not cover any
damage caused by the non observance of any of
these instructions.

Please read these instructions before installing or
using this appliance for the first time. This guide must
be kept and given to any new user.

Please, check that the voltage in the rating label fits
the power supply.

The surfaces of the towel rail can be hot and caution
is advised when small children are near the appliance.

Warning: In order to avoid a hazard for very young
children, this appliance should be installed so that
the lowest heated rail is at least 600 mm above the
ground.

Before carrying out any work inside the appliance, the
towel rail must be disconnected from the electricity
supply.

The use of electric towel rails is forbidden in any area
where there is a presence of gases, explosives or
inflammable objects.

The towel rail should not be installed exactly under an
electric outlet.

The appliance must be installed in such a way that it is
impossible for anyone using a bath or shower, to
touch the controls.

The installation must be carried out in accordance
with the current electrical regulations.

The supply lead must not contact the surface of the
towel rail.

If the supply lead of the towel rail is damaged it must
be replaced by service personnel authorized by the
manufacturer, since special tools are needed.

The presence of air particles of smoke, dust and other
pollutants could, in time, discolour the walls and
surfaces around the towel rail.

All the models incorporate a safety device. This will
disconnect the towel rail if for some reason it fails. If
the safety device activates the towel rail will need to
be repaired by service personnel authorized by the
manufacturer.

2. INSTRUCTIONS FOR INSTALLATION

The towel rail is designed to only work in a vertical position
and fixed to the wall, never to the ceiling.
The fixation to the wall is carried out by means of the
supports given with the appliance, according to the following
outline.
A clear distance of 5 cm must be allowed around the towel rail.
Cable exit always on the lower right side.
The towel rail supports should be placed in sequence as
indicated below:
Connect the wires to a fix wall socket or to an appropriate
plug WITHOUT EARTH. Connect the black wire marked "Fil
Pilote" to the signal wire when available. Do not connect this
wire to any EARTH lead.
4