Incoming Plumbing Elevation - Hunter STK-1 Instrucciones De Instalación

INSTallaTIoN INSTruCTIoNS for huNTEr STK-1
as a reference below. The rim of the enclosure is the exposed upper
surface that surrounds the enclosure's covers once they are installed.
The quick coupler inlet piping needs to be 5" from the inner rim of
the enclosure at the top and 5" from the inner rim of the enclosure
on the right side (#20).
"OFF FIELD SIDE"
"ON FIELD SIDE"

Incoming Plumbing Elevation

The swing joint's inlet piping location and depth is critical. This
location and depth in conjunction with the special multi-axis vertical
alignment "VA" swing joint allows the rotor to be placed and
leveled within the hole in the enclosure's cover. Use the Side View
of the following installation detail as a reference. Note that the VA
swing joint's first horizontal section is resting at a level that is at the
same level as the bottom of the enclosure (#18). This depth is 26"
from the top of the enclosure.
6
The quick coupler inlet piping (#10) must align with the quick coupler
access hole in the enclosure's cover (#20). Also, in order for the quick
coupler key with its handle attached to operate the quick coupler
valve, the quick valve must be installed as close to the underside of the
main cover as possible. Use the Side View illustration shown below as a
reference. The quick coupler must be installed so that the final elevation is
approximately ½" below the underside of the main enclosure cover (#16).
NoTE: The STk-1 is designed for block type
irrigation systems with remotely located control
valves. Since ST rotors do not include a check
valve within the rotor, it is imperative that the
remotely located control valves are installed at
the same elevation as the rotor's inlet or below
the elevation of the rotor's inlet.
"VIEW FROM ON FIELD SIDE"
ENG