KINZO 25C5030 Manual De Instrucciones página 48

Remove the collet nut and the old collet (9).
I
I Place the new collet.
Replace the collet nut.
I
Release the spindle lock button.
I
Switching on and off (fig. A)
I To switch the machine on, set the on/off switch (1) to 'I'.
To switch the machine off, set the on/off switch (1) to '0'.
I
Adjusting the speed (fig. A)
This machine has been fitted with an adjusting wheel (2) for the
maximum speed.
Turn the adjusting wheel (2) as indicated on switch (1) to set the
I
maximum speed.
Polishing (fig. A & B)
A polishing wheel is used for polishing metal and plastic workpieces.
A mandrel is used for mounting a polishing wheel.
Place the mandrel (14) in the collet nut (6).
I
I Place a polishing wheel (19) on the screw.
Cutting and sanding (fig. A & B)
A cutting disc is used for cutting metal, plastic, wooden and stone
workpieces. A sanding disc is used for sanding wooden and plastic
workpieces. A mandrel is used for mounting a cutting disc or sanding disc.
Place the mandrel (15) in the collet nut (6).
I
Loosen the screw on the mandrel.
I
I Place a cutting disc (21) or sanding disc (20) on the screw.
Place the screw on the mandrel and tighten it.
I
48
25C5030_20.p7
Always unplug the tool before replacing the collet.
Choose a low speed for working wood and plastics.
I
Also choose a low speed for polishing.
I
48
25C5030
04-06-2004, 15:29