Fagor PPV-20 Manual De Instrucciones página 9

INTERIOR .qxd 23/3/04
• People with nervous disorders should not use the
straightening irons on their own, to avoid any possible
risks.
• Do not leave the straightening irons unattended when
they are plugged in, even for a short time, because
they are potentially dangerous.
• Do not use the device together with a hair spray or
tonic or any other chemical product because they
could contain flammable substances.
• Installing a circuit breaker protection device offers
added safety, ensuring that 30 mA of its electrical
installation are not exceeded. Follow your installer's
indications.
• Do not leave the device on surfaces that are
- hot.
- not heat resistant.
- soft or padded such as a cushion or a blanket
• If the connection cable is damaged, it must only be
replaced by a technical service authorised by the
manufacturer.
• This device is for household use and it must not be
used for a purpose other than the one described in
this manual. Do not use the straightening irons for
any action other than straightening hair.
• The pilot light does not exceed the laser class 1 in
accordance with IEC 825-1.
• Waste removal: When you decide to take the device
out of use, making it unusable and to get rid of it, the
suitable waste removal procedure must be followed.
For more information on this subject, contact the local
authorities.
10:15 Página 7
This device has an automatic steam output function
that makes the device give off steam when it reaches
the right temperature.
Filling of the tank
The removable water tank is on the top of the device.
Turn the device off and let it cool off.
Press the unhooking buttons and remove the tank
Turn the fuse holder 90º anti-clockwise and remove it
from the tank.
Fill the tank up to the filling hole.
Place the fuse holder in the hole and turn it clockwise
until it reaches its limit.
Dry the tank and put it back in position on the device.
Only use tap water to fill the tank.
The straightening irons may be also be used without
the steam function.
Turning it on
Place the device on a flat, heat-resistant surface and
connect it to the mains.
Move the switch to position I.
After 5 to 7 minutes, the device will reach the correct
temperature to work; this is the most suitable
temperature for the hair and it remains constant.
The pilot light remains on while the device is plugged in
and the plates are heating up.
8
4. OPERATION (PPV-20)