Inglesina Cab 0+ Manual De Instrucciones página 30

HEADREST AND HARNESS ADJUSTMENT
fig. 5 To loosen the harness, use the adjustment button (K) by putting a finger in
the slot in the seat (K1) and pulling the belts inside the infant seat at the same time.
fig. 6 Release the central buckle for the harness, using the red button (C), and
settle the child in the child car seat with their back and legs entirely in contact with
the seat.
fig. 7 The harness and headrest (F) can be adjusted in 5 positions simultaneously
to adapt to the growth of the child.
To adjust the height, use the rear adjustment lever (J) and at the same time raise or
lower to the correct position, which can be identified by the Click.
fig. 8 Overlap the two ending parts (C2) and insert them in the buckle (C1) until
hearing the blocking CLICK. Verify the correct closing by pulling the ends of the belts.
fig. 9 Let the belts adhere to the child's body, by pulling its end on the regulator
(K2). A finger should not pass between the belts and the child's body. To loosen the
same, see Fig. 5.
fig. 10 To release the belts, press the red button (C).
ADAPTER
fig. 11 The child car seat is equipped with an adapter (D) to be used for children up
to about 3 months of age.
USE OF THE HOOD
fig. 12 The child car seat is equipped with an adjustable hood (E).
To attach it, insert the ends (E1) in the dedicated slots (E2) and then insert the various
attachments (E3) around the structure.
fig. 13 To adjust it, simply accompany it to the wished position.
fig. 14 To remove the hood (E), extract it firmly from the structure.
CAUTION: the hood shall not be used to lift the child car seat: hazard of
detachment.
CARE AND MAINTENANCE
It is recommended to remove the lining periodically to provide for its correct
maintenance.
fig. 15 Bring the handle (A) to the most rear position.
fig. 16 Remove the lining from the headrest (F).
Extract the protections from the belts.
fig. 17 Remove the lining from the structure, freeing the attachments (V1) from
their housings.
fig. 18 Extract the belts from the suitable eyelets and, then, remove the entire
lining.
INSTALLATION ON BOARD WITHOUT BASE
Verify that on the vehicle seat there are not any items that may hinder the correct
leaning of the Inglesina Cab 0+ child car seat.
Verify that the backrest is in vertical position and the vehicle seat where the child car
seat has to be installed is NOT EQUIPPED WITH FRONT AIRBAG.
Install the Inglesina car system only IN THE OPPOSITE DIRECTION TO THE DRIVING
ONE.
fig. 19 Pass the lower segment (S1) of the car safety belt through the lateral seats
(G1).
fig. 20 Hook the car safety belt properly.
30