Juiceman Customer Care JM480S Manual Del Usario página 10

DISASSEMBLING THE CITRUS JUICER
1. Lift the juice spout into the closed ( ) position.
2. Remove the juice pitcher from under the spout.
3. To unlock the locking latches, pull open at the bottom of each latch to
disengage from the tabs on the cover. The latches will raise and be released
from the cover (see M).
4. Lift the juicing cone assembly from the citrus juicer attachment.
5. Lift the citrus juicer attachment from the integrated pulp container.
6. Lift the pulp container and the drive shaft from the base.
10
ASSEMBLING THE CITRUS JUICER
1. Place the integrated pulp container on the motor
base.
2. Place the citrus juicer drive shaft into the center
of the integrated pulp container and press down to
make sure it is seated securely on the base (K).
3. Place the citrus juicer attachment on top of the
integrated pulp container so that the two small lock
tabs are to the right and left (L).
K
4. Lock the locking latches by holding down the cover
as you as you fit the locking mechanism at the
top of each latch over the tab on each side of the
attachment (M). Press the bottom of each latch
until you hear it click into place.
Important: The appliance will not operate until the
locking latches are locked.
5. Place the juice pitcher under the juice spout.
6. Tilt the juice spout into the open ( ) position
(see G on page 7).
L
7. Choose your desired citrus cone and place on the
drive shaft (see USING THE JUICING CONES).
USING THE JUICING CONES
Note: The small cone is recommended for small
fruits, such as lemons and limes and the large cone
for larger fruits, such as oranges and grapefruit.
1. Hold the small juicing cone in one hand by
the 2 prongs. Place the thumb and forefinger of
the other hand on the large juicing cone
directly above the prongs. Press lightly and lift the
M
conecompletely off. The small juicing cone will be
revealed.