Installation Instructions - Gabarron ADL 2012 Instrucciones De Instalacion Y Uso

• The presence in the air of particles of smoke, dust and other pollutants could, in time, discolour the walls
and surfaces around the heater.
CAUTION — Some parts of this product can become very hot and cause burns. Particular attention must
be given when children and vulnerable people are present.
WARNING: In order to avoid overheating do not cover the heater.
2. INTRODUCTION
Storage heaters are designed to take advantage of the off-peak tariff.
The heaters consume electricity only during the off-peak tariff, but due to the highly efficient storage medium, give you a truly
economical 24 hours of comfort temperatures.
The input control operates a highly sensitive thermostat which regulates the amount of heat stored.
The discharge takes place when the built-in blower operates. The blower drives fresh air through the core and is heated. A
bimetallic device mixes the hot air with fresh air to provide homogeneous temperature.
It is important that the correct rating of heater is installed to provide the selected level of heat. This will ensure the best possible
running costs against other fuels.
To avoid transport problems, the heater casings and storage bricks are packed separately. The bricks with some slight defects
in the corners can be used.
You should be aware that storage heaters, when fully charged, can have high surface temperatures.

3. INSTALLATION INSTRUCTIONS

Installing the controlled storage fan heater:
1.- Chose the right place to install the heater, considering the
minimum distances between heater and other objects. It is needed
a minimum distance of 50 cm to assure a good heat delivery.
2.- Open the carton box by the indicated side, and remove the box
containing the accessories, electrical elements and parts to fix to
the wall. Turn upside down the box so the heater stands up on its
feet and remove the shipping carton. Check if it is the requested
model and it is in brand new conditions.
3.- Screw on the wall the fixing part, making drills at 61 cm over de
floor (Fig. 1).
This device prevents the heater overturning when a force of up to
20kg is applied to the upper parts to the exterior. The function of
the device is not to hang the heater. If there is any doubt as to the
strength of the wall, please consult an expert. Storage heaters are
very heavy and the installer must ensure that they are securely
fixed and there is no possibility of them overturning.
4.- Remove the front outlet grill by removing the four screws. Remove also the front panel by removing the two screws at the
bottom of the heater.
5.- Attach the LH & RH spacers to the storage heater using the screws supplied, in the same way as the screws are fixed in the
upper rear section of the heater side. Check the heater is separated 25mm from the wall at the top and bottom of the heater
(Fig. 2). Fit and screw the appliance to the anti-tilt device.
6.- Remove the inner front panel.
8
fig. 1