KREBS MAXPRO MPPO1200/180VC Manual Del Usuario página 9

P P olisher MPPO1200/180VC User Manual
7 Speed control
- < from low to high (1-MAX)
- <
- if needed, select a higher speed while the tool runs
- the optimal working speed depends on the material and can be determined with practical trials
5
<
8 Operating the tool
- switch on the tool
- place the tool fully on the surface to be polished and move it evenly by sections
- one move should overlap the previous move by one half
- do not stop at a single spot to avoid burning the coating
- do not move the tool in circles to avoid staining or burning the coating
! before switching off the tool, you should lift it from the workpiece
! the accessory continues to rotate for a short time after the tool has been switched off
9 Holding and guiding the tool
! while working, always hold the tool at the area(s)
- always hold the tool firmly with both hands, so you will have full control of the tool at all times
- provide for a secure stance
! do not apply so much pressure on the tool that it comes to a standstill
- keep ventilation slots L uncovered
6
9 GB