Punktal PK-640CE Manual De Usuario página 21

A – On/Off Button: used to start and stop the motor. The motor starts running in 2
pushed for the first time.
B – Minus Button:
C – Digital Display: shows in which cycle the motor is.
D – Plus Button: used to increase the cycle of the motor with one level.
E – Timer Button: when this button is pushed, the cycle of the motor flashes on digital display and the motor stops
within 15 minutes. It is necessary to keep pushed this button for 3 seconds to activate it. Push only one time to cancel
it.
F – Bulb Button: used to turn on and off the bulb.
INFORMATION ABOUT MAINTENANCE
Section 7-1
Plug out the product, or turn off the power switch, or loosen or turn off the safety fuse supplying the chimney hood,
before starting maintenance operation.
Aluminum Filter
This filter is used to catch the oil particles in the air and, thus, it will be blocked after a period of time which will change
depending on the frequency of use of the device. We recommend that this filteri s cleaned once a month at most to
make sure that the device does not pose a danger. For this operation, firstly, remove the aluminum filter. Wash the
filters with liquid washing agent and flush, and mount it on its place after drying. The change in color may be observed
as the aluminum filters are washed. This is normal and there is no need to replace the filters. It is also possible to
wash the aluminum filter in the dishwashing machine.
Removing Aluminum Filter
1. Push the lock of the aluminum filter forward.
2. Then, slightly lower it downwards and push forward. Otherwise, the filter can be defected. Wash the aluminum filter
and mount it again into its place by applying the steps mentioned above in reverse.
Carbon filter (it is for flueless use)
This filter removes the cooking smell. It cleans the circulating air within the kitchen in case there is no possibility to
use chimney. Physical life of the carbon filter of the device will expire depending on the frequency of use and mode
of cooking, and that of aluminum filter will expire depending on the cleaning regularly.
In usual use, it should be replaced once in every 4 months at most.
Removing Carbon Filter:
1. Remove the aluminum filter.
2. To remove the carbon filter, turn it to the left and pull it towards yourself.
3. Mount a new carbon filter.
4. Mount the aluminum filters.
Section 7-2
Use soft cloth wetted with water to clean the exterior surface of the chimney hood. Never use abrasive and scratching
products for cleaning. The cloth must be applied in the same direction with the brush in order to avoid scratching of
the steel drum. The bulb glasses must not be removed during cleaning.
reduces the cycle of the motor.
nd
cycle when On- Off button is
7