Honeywell RTH7500 Serie Guía De Instalación Rápida página 12

Quick Installation Guide
Program schedule override (temporary)
1
Press + or - to adjust the temperature.
2
Once at the desired setpoint
temperature, no further action
is needed. The new setpoint
temperature will be held until the
next scheduled time period begins.
For more information on schedule
time periods, see "Program Schedule"
on page 11.
3
To cancel the Temporary Hold, Press
+ or - and then press Cancel.
Program schedule override (permanent)
1
Press + or - to adjust the temperature.
2
TEMPORARY HOLD is displayed
and the setpoint temperature flashes.
While it's flashing, press Hold (Mode)
button to change to Permanent Hold.
3
To cancel the Permanent Hold, press
+ or - and then press Cancel.
Wiring—conventional systems
Alternate wiring (conventional systems)
If labels do not match terminals, connect wires as shown below (see notes, below).
NOTES:
1. If you must connect both R and Rc wires, set the R Slider Tab to the down
position (2 wires).
2. If your old thermostat had both R and RH wires, set the R Slider Tab to the
down position (2 wires). Then connect the R wire to the Rc terminal, and the
RH wire to the R terminal.
3. If your old thermostat had only 1 C or C1 wire, connect it to the C terminal. If
your old thermostat had 2 C or C1 wires, wrap each separately with electrical
tape and do not connect them.
S
S
Y1 M
or or
Y
Y Y
2
or F
G
or C1 or X or B
3
C
U
U
Temporary Hold
Permanent Hold
A
L/A
O/B
W
2
AUX
E
or W1 or
W
K
or R
R
or RH or
Rc
12
H
2 2
4 or V