Record Markers In Tour Mode; Pause Tour Mode; Deactivate Tour Mode - Oregon Scientific Outbreaker Mountain-Ski Manual De Uso

1. Simultaneously press FUNC / SET and MODE. The
TOUR END screen will display.
2. Press and hold FUNC / SET for two seconds. The TOUR
number (T1, T2, etc.) will show at the bottom of the display.
You are now recording information. The percentage (%)
at the top indicates the total used memory.
3. To stop the TOUR, press and hold FUNC / SET for 2
seconds. END will show at the bottom of the display.
The Tour data will be stopped.
4. To begin another TOUR, press and hold FUNC / SET
for 2 seconds. The new TOUR number (T3, etc.) will
show at the bottom of the display. You are recording
information again.
5. Press MODE to return to the clock display.
NOTE Used watch memory is given as a percentage. It is
recommended that you download information to your PC
and clear all TOUR memories when this figure approaches
100%. When the used memory hits 100% it will no longer
record, and any future readings will not be recorded.

RECORD MARKERS IN TOUR MODE

The marker function is used to mark a particular position
during a TOUR. To place a marker, press and hold
SELECT / - when the TOUR Mode is in use. The marker
will only be shown in the PC data, once it has been
downloaded from the watch.

PAUSE TOUR MODE

1. If you are not already in TOUR Mode, simultaneously
press FUNC / SET and MODE. The TOUR number
will display. The percentage (%) at the top indicates
the total used memory.
2. Press FUNC / SET. REST shows at the bottom of the
display.
3. Press ST / SP to turn the rest on (paused) or off
(recording).

DEACTIVATE TOUR MODE

For best results, perform these steps immediately after
you end your trip.
19