Tabla de contenido
Idiomas disponibles
Idiomas disponibles
CUTTING ERRORS
INSUFFICIENT PENETRATION
This error may be caused by the following:
• High speed. Always make sure that the arc fully penetrates the workpiece and is never held
at a I forward angle of more than 10-15°. This will avoid incorrect consumption of the nozzle
and burns to the nozzle holder.
• Excessively thick workpiece (see cutting speed diagrams, Picture 7).
• Grounding clamp not in good electrical contact with the workpiece.
• Worn nozzle and electrode.
• Cutting current too low.
NOTE: When the arc does not penetrate, the molten metal scraps obstruct the nozzle.
THE CUTTING ARC GOES OFF
This error may be caused by:
• Worn nozzle, electrode or swirl ring.
• Air pressure too high.
• Supply voltage too low.
SHORTER LIFE OF CONSUMER PARTS
This error may be caused by:
• Oil or dirt in the arc intake.
• Unnecessarily long pilot arc.
• Low arc pressure.
Make sure that the new electrode and nozzle to be mounted are thoroughly dean and degreased.
Always use original spare parts to avoid damaging the torch.
SOLTER
SOLDADURA S.L.
SOLCUT
Tabla de contenido
