Maintenance; Solutions To Most Frequent Anomalies - Sima B-50/I Manual De Instrucciones Original

• The protections are not supposed to be removed while the machine is functioning. The machine is to be
disconnected from electricity for any mechanical or electrical manipulation.
• Do not use high pressure water to clean circuits and electrical elements.
• Disconnect the machine from electricity and do not manipulate nor operate on neither the mechanical nor
the electrical elements while the machine is functioning.
SIMA, S.A. is not responsible for the consequences possibly generated but the inadequate of the machine.

6. MAINTENANCE

• The vacuum cleaners require a simple maintenance as per the following steps:
• Clean vacuum-cleaner prior and after use.
• Clean the trimming in the head cover.
• If the vacuum-cleaning strength decreases, please control and clean the filters
ATTENTION: If the filter is washed with water, make sure it is completely dry before placing back it in the
machine.
• Control the state of the tubes and replace frequently any electrical cable that causes cuts, breakage or any
deterioration. Use original parts.
• Maintenance is preferentially to be made by persons well acquainted with the machine and its functioning.
• Any manipulation of the machine must always be made with the motor stopped and the electricity cable
disconnected. Do not forget to remove all used equipment and tools.
• In case of observing anomalies badly or operation, makes review the machine by a specialized technician.
• To always consider the mentioned recommendations of security in this manual.
• At the end of each day, switch off the machine and disconnect it from the electricity source.
• In case you notice any anomaly or bad functioning, let the machine be controlled by an authorised technician.
• Always take into account the safety recommendations mentioned in the present manual.
It is prohibited to bring any type of modification in any part, element or characteristic of the
machine without prior authorisation of SIMA S.A. The latter will not be in any case responsible for
the possible consequences from the breach of these recommendations.

7. SOLUTIONS TO MOST FREQUENT ANOMALIES

ANOMALY
Motor does not start up
Vacuum cleaning decreases slowly
Vacuum cleaning decreases rapidly
Dust comes out during vacuum
cleaning
POSSIBLE CAUSE
No electrical stream
Dirty filter
Defect filter or full deposit
Defect or incorrect filter
7
SOLUTION
Control feeding table, plug and
electric cable
Review, clean and control the
vacuum-cleaning
Replace filter. Empty deposit
Control filter ring. Replace filter
ENGLISH