Setting Up The System; Placing The System; Connecting To Power; Setting The Clock - Bose Wave Music System IV Guia Del Propietario

Setting Up the System

Placing the system

• To enjoy maximum audio performance:
— Place the system across the room from where you listen.
— Place the system within two feet of a wall, and avoid placing
directly in a corner.
• Place the system on a flat, stable surface.
CAUTIONS:
• Do not place the system on a metal surface. It could interfere
with AM reception.
• Do not place the system on a heat-sensitive surface. Like all
electrical equipment, it generates some heat.
• Do not use the system in a damp location or any other place
where moisture can get inside.

Connecting to power

1. Insert the small end of the power cord into the
AC POWER connector.
2. Plug the power cord into an AC (mains) power outlet.
6 - English

Setting the clock

After plugging in the system, set the clock using the remote.
1. Press and hold either Time – or Time + for about one second.
Note: Press-and-hold operations require holding the button
down for about one second.
Initially, HOLD TO SET appears on the display and then
quickly changes to – CLOCK SET – as the button is
depressed.
2. Release the selected Time button.
3. Press Time – to adjust the displayed time backward or press
Time + to adjust the displayed time forward until it matches
the current time. You can also press and hold for rapid
adjustment.
4. Wait five seconds for the system to exit clock setup mode.
Notes:
• To change the clock from 12-hour (AM/PM) time to 24-hour time,
see "Changing a system setting" on page 14.
• If the system loses power due to a power outage or if you
unplug the system, all system settings are permanently retained.
However, the clock time is only temporarily stored in backup
memory for up to 48 hours.