FALMEC Panoramico 90 Manual De Instrucciones página 22

To modify time repeat the procedure from point 1.
To cancel timer:
1. If off, turn the hob on and touch (+) and (-) at the same time.
(on the Plus version the lamp is on
2. Touch the key ( - ) to bring time to 00.
AUTOMATIC SHUTDOWN
For the automatic shutdown function:
1 - turn on the cooker;
2 - select the cooking area;
3 - select the level;
4 - set the timer as described above.
To set the automatic shutdown for another cooking area, repeat the procedure
from point 2.
TIMER and AUTOMATIC SHUTDOWN can be used simultaneously.
ADDITIONAL FUNCTIONS
"90 PLUS" MODEL
STOP AND GO
This function allows to temporarily stop cooking and restore it with the same
settings.
to enable touch the key .
If the function is not deactivated within 10 minutes, the cooker switches off.
For deactivation
Touch the key and within 5 seconds completely slide the slider to right.
AUTOMATIC PROGRAMMING OF THE COOKING
This function allows to speed up the start of cooking.
The procedure is the following:
1 - turn on the cooker
2 - touch for more than 2 seconds the desired level of cooking:
on the display will be displayed and the desired level of cooking
For a certain period the cooking area will work at the maximum power to then
rech the set level.
To deactivate the function:
touch again the control
RESET FUNCTION FOR ACCIDENTAL SWITCH OFF
After turning off the cooker, it is possible to restore the last selected settings:
· Status of cooking of all cooking areas (power).
· Minutes and seconds of the timer by programmed cooking areas.
· Automatic programming of cooking.
The restore procedure is the following:
- turn on the cooker.
· touch within 6 seconds the key .
Previous settings are restored.
CHEF FUNCTION
It allows setting for each cooking area pre-defined power for each cooking pha-
se.
AREA 4:
power level 9. Cooking start.
AREA 3:
power level 6. Cooking continuation.
AREA 2: power level 3. Cooking end.
AREA 1:
power level 1. Keep warm.
).
and change the power level.
TOUCH PUSHBUTTON PANEL
(For use with remote hoods)
ON/OFF
Motor on/off and Speed 1
Speed 2 activation
Speed 3 activation
Speed 4 is only active for a few minutes, then speed 3 activates.
Light on/off
Short pulse: light on/off
Long pulse: change of light tone from 2700K-5600K (hoods with dynamic
light ( )
TIMER (red LED flashing)
Auto switch-off after 15 min.
CODE CHANGE ON HOOD CONTROLS
In case of only one hood control, go to item 2.
In case of several control positions in the same room, a new code can be created
by following the procedure below.
Disconnect the power to the hood before starting the procedure.
1) - CREATE A NEW CODE
The procedure is to be carried out using the pushbutton panel found on the
hob.
.
• Press LIGHT and TIMER
• Press the 2nd speed
Reconnect the hood to the electrical power supply, making sure
that the lights and motor are off.
2) - ASSOCIATION BETWEEN THE HOB CONTROLS AND THE HOOD
press LIGHT or TIMER
pushbutton panel for 2 seconds:
the key turns on.
press the LIGHT key on the hob within 5 seconds.
RESTORING DEFAULT CODE
the procedure is to be carried out if the hob is disposed of, sold or transferred.
Disconnect the power to the hood before starting the procedure.
• Press LIGHT and TIMER
• Press the and speed keys for a few seconds.
• Perform the procedure described in point 2.
22
simultaneously until the display starts flashing.
key for a few seconds.
(see the instruction manual for the hood) on the hood
at the same time until the keys start flashing.