Important Use Guidelines; Operating Specifications - Nikken PIMAG DELUXE 13151 Manual De Instrucciones

1. Read this manual completely before attempting to install or use the PiMag Deluxe
Under Counter Water System.
2. Do not use with water that is microbiologically unsafe or of unknown quality without
adequate disinfection before or after the system. Systems certified for cyst reduction
may be used with disinfected water that may contain filterable cysts.
3. Individuals requiring specific microbiological purity should consult their physician.
4. For use on cold, potable water supplies only.
5. For this unit to perform as represented in the performance data sheet, use only Nikken
PiMag Deluxe filter cartridges, Item #13152.
6. This system must be protected from freezing. Failure to do so may result in loss of
performance, damage to the parts and water leakage.
7. Installation of this product must comply with all state and local laws and regulations.
Refer to your local agencies for details.
8. The contaminants or other substances removed or reduced by this water treatment
system are not necessarily in all users' water.
MASSACHUSETTS RESIDENTS PLEASE NOTE:

IMPORTANT USE GUIDELINES

The Commonwealth of Massachusetts Plumbing Code 248CMR shall be adhered to.
A licensed plumber shall be used for the installation of this product.

OPERATING SPECIFICATIONS

Model
Use
Dimensions
Rated Service Flow
Rated Capacity
Working Pressure
Operating Temperature Maximum: 100°F (37.8° C), Minimum: 34°F (1° C)
Cartridge Replacement Item No. 13152
BASIC TOOLS REQUIRED (NOT SUPPLIED)
Instructions for drilling a hole in your sink (if required) are included in this manual.
• Utility knife
• Ruler
• Pencil
• Hammer
If you are hesitant to drill a hole in your sink, or if you lack the proper tools, consult a
licensed plumber in your area for installation of this system.
PiMag Deluxe Under Counter Water System — #13151
Potable, cold water only
10.8" x 6.3" (27.43 x 16 cm)
0.75 gal/min (2.84 L/min)
800 gallons US (3028 liters)
Maximum: 125 psi (862 kPa), Minimum: 30 psi (207 kPa)
• Masking tape
• 5/8" drill bit
• Punch
• Drill
4
• Wrenches – 1/2" & 9/16"
• Screwdrivers –
flat & Phillips
• Eye protection
®