Dismantling The Appliance; Removing The Appliance - Ondal Acrobat 2000 WA04/75 Instrucciones De Montaje

4

Dismantling the appliance

Only dismantle appliance in position A
4 Dismantling the appliance
Please be sure to observe the safety information in section 1.
4.1 Limit the height of the spring arm to position A
Figure 5
WARNING – Sudden release of spring arm
If the appliance
arm

Lock the spring arm
dismantle the appliance
position A..
1. Put the spring arm
2. To lock the spring arm
all the way to the right..
3. Check that the spring arm
4.2

Removing the appliance

Figure 6
WARNING – Electric shock hazard:
Isolate the Acrobat 2000 from the power supply.
1. Remove the plug
again unintentionally.
Switch off the ON/OFF switch
precautions to prevent them being switched on again.
2. Unscrew countersunk screw M3 x 8 mm
3. 3. Lift up the sleeve
4. Remove the locking segment
5. Take the appliance
6. Insert the protective cap
locking segment
7. Turn the sleeve
countersunk screw M3 x 8 mm
8. Screw in countersunk screw M3 x 8 mm
9. Mark the wall arm as DEFECTIVE on the plug
10. Take precautions to prevent the plug
Take precautions to prevent the ON/OFF switch
again.
is not dismantled in highest position, the spring
is suddenly released upwards and may cause serious injury.
in the horizontal position A, and only
in the horizontal in the horizontal
into the horizontal position A.
, insert size 5 Allen key into the hole ① and turn
is securely locked in position A.
and take precautions to prevent it being plugging in
and wall power supply and take
a little, turn it to the right and slide upwards.
with a narrow slot-head screwdriver.
out of the spring arm
into the spring arm
.
a little to the left and slide downwards until the
can be fitted.
18
:
.
.
, insert
and tighten.
and ON/OFF switch
from being plugged in again.
from being switched on
GB
D
.