Using The Soundbar - Lenco SB-080 Manual De Usuario

Operating INSTRUCTIONS

Using the soundbar

1. Switch on the soundbar by using the power button on the soundbar or by
using the Standby button on the remote control. After switching it on, the
default input mode will Be shown on the display
2. lnput modes can be changed by pressing the power button again or by using
the INPUT button on remote
Below are input mode names appearing in the soundbar display:
Note: USB input mode is not available in the source selection. lt will be available
only after inserting a compatible USB Drive (appears as US in display)
Pairing Mode
Connect
1. Plug in the power cord and the display will lit up, display shows [--] which
means the unit is in standby mode
2. Switch on the soundbar by pressing the power button and then change the
input mode to Bluetooth. The display will show [bt]. If no device was
previously paired, the display will show a blinking [bt].
3. Search for new Bluetooth devices on your Bluetooth audio player (for
example: smartphone/tablet/computer). Choose the device named 'Lenco
SB-080' from the list of the detected devices. lf a password is requested just
type 0000. The blinking [bt] will stop flashing and a beep will sound when the
sound bar is successfully paired.
4. The soundbar will remember the last paired device and reconnects the next
time you switch on the soundbar in Bluetooth mode. (The previously paired
device must be in the neighborhood of the sound bar with the Bluetooth
function activated)
Note: When your device was unable to detect the soundbar while pairing, please
restart the bluetooth mode and try to pair again.
Disconnect
Go to the Bluetooth settings of your Bluetooth audio player, select 'Lenco
SB-080' from the list of devices and choose the option 'disconnect'.
Note: You have to disconnect from your Bluetooth audio player if you want to
connect a different BT player.
7