Installation; Din Front/Rear-Mount; Take Out Screw Before Installation; Din Front-Mount (Method A) - Vieta Car VC-HU520BR Manual De Usuario

Installation

Notes
Choose the mounting location where the unit will

not interfere with the normal driving function of the
driver.
Before finally installing the unit, connect the wiring

temporarily and make sure it is all connected up
properly and the unit and the system work properly.
Use only the parts included with the unit to ensure

proper installation. The use of unauthorized parts can
cause malfunctions.
Consult with your nearest dealer if installation

requires the drilling of holes or other modifications of
the vehicle.
Install the unit where it does not get in the driver's

way and cannot injure the passenger if there is a
sudden stop, like an emergency stop.
Avoid installing the unit where it would be subject 
to high temperature, such as from direct sunlight,
or from hot air, from the heater, or where it would be
subject to dust, dirt or excessive vibration.

Din front/rear-mount

This unit can be properly installed either
from "Front" (conventional DIN Front-mount) or "Rear"
(DIN Rear-mount installation, utilizing threaded screw
holes at the sides
of the unit chassis). For details, refer to the following
illustrated installation methods.

Take out screw before installation

Before installing the unit, please remove the two
screws.

Din front-mount (Method A)

Installation Opening
This unit can be installed in any dashboard having an
opening as shown below:
16

Installing the unit

Be sure you test all connections first, and then follow
these steps to install the unit.
1. Make sure the ignition is turned off, and then
disconnect the cable from the vehicle battery's
negative (-) terminal.
2. Disconnect the wire harness and the antenna.
3. Press the release button on the front panel and
remove the control panel (see the steps of "removing
the front panel").
4. Lift the top of the outer trim ring then pull it out to
remove it.
5. The two supplied keys release tabs inside the unit's
sleeve so you can remove it. Insert the keys as far
as they will go (with the notches facing up) into the
appropriate slots at the middle left and right sides of
the unit. Then slide the sleeve off the back of the unit.
6. Mount the sleeve by inserting it into the opening of
the dashboard and bend open the tabs located around
the sleeve with a screwdriver. Not all tabs will be able
to make contact, so examine which ones will be most
effective. Bending open the appropriate tabs behind
the dashboard to secure the sleeve in place.
(1) Dashboard;
(2) Tabs
(1) Front panel;
(2) Outer trim ring;
(3) Sleeve;
(4) L key;
(5) R key
USB/SD Radio