Dimmer Control - Tokai TCP-137 Manual De Instrucciones

NAP FUNCTION (count down timer)
In radio off mode, press NAP button (8) button to enter into the NAP
mode, the NAP time 90 will be displayed during 5 seconds. In the
meantime, press repeatedly NAP button (8) button to set the duration
time from 90 min to 10 min.
Once time is up, the alarm buzzer will sound for 30 min and then shut
off automatically. To stop the alarm buzzer, press the ON/OFF button
(9).
Press the NAP button (8) button has no effect during alarm operation.
Press ON/OFF button (9) to cancel the NAP function.

DIMMER CONTROL

In standby mode, press the DIMMER (1) button allows you to set the
brightness of the LED display to high, medium ,low 3 levels.
DAYLIGHT SAVING TIME (DST) MODE
For countries with daylight saving time (DST) (one hour of difference
between summer time and winter time), this clock radio offers you
DST option to adjust summer time.
In standby mode press and hold for 3 seconds the DST button (1).
The clock advances by one hour. To exit DST mode, repeat the above
operation.
PROJECTION UNIT
Note: project time image on the ceiling or wall of a darkened room.
The maximum projection distance is 0,90 M ~ 2,70 M.
Focus setting:
- Adjust the brightness & focus (11) of the projected clock by turning
the adjustable focus wheel until the projected time is clearly shown
on the ceiling or wall.
- Adjust projected direction thanks to the angle adjustment.
- Flip the projected image by 180° by pressing 180° FLIP (3) button.
RESET
If the system does not respond or exhibits erratic or intermittent
operation, you may have experienced an electrostatic discharge
(ESD) or a power surge that triggered the internal microcontroller
19