Environmental Protection; Fitting The Stand - Triton TRBS12 Instrucciones De Funcionamiento

SYMBOLS

ENVIRONMENTAL PROTECTION

Waste electrical products should not be
disposed of with household waste. Please
recycle where facilities exist. Check
with your local authority or retailer for
recycling advice.
Always wear ear, eye and respiratory
protection.
Conforms to relevant legislation
and safety standards.
SETTING UP
Prepare the workplace in the location where
the machine is to be operated. Ensure there
is sufficient room to allow safe operation. The
machine must be placed on a firm, level surface.

FITTING THE STAND

1. With the bandsaw
resting on its side, on
the ground, fit the Legs
(5) onto the internal
edges of the bandsaw
base using three M6 x
12mm Hex Bolts (36),
Flat Washers (39), Spring
Washers (38) and M6 Hex Nuts (37) per leg,
as shown. Finger-tighten only.
2. When all the legs are
loosely fitted, position
the Tray (4) between
the four legs, with the
flanged face pointing
away from the machine.
Loosely fix the tray into
position using M6 x
12mm Hex Bolts (36), Flat Washers (39),
GB
Spring Washers (38) and M6 Hex Nuts (37).
3. Tighten all the bolts
securing the stand to
the bandsaw and then
those holding the tray
in position.
Symbols / Setting Up
6
Instruction warning.
Instruction note.
Do not use before viewing and
understanding the full operating
instructions.
Double insulated for additional
protection.
4. With assistance, carefully lift the bandsaw
upright, ensuring the feet locate firmly on level
ground. If there appears to be any rocking
movement in the stand, loosen all the bolts
and re-tighten.
5. Screw the Wheel
Brackets (3) onto the
rear legs using M6 x
12mm Hex Bolts (36),
Flat Washers (39),
Spring Washers (38)
and M6 Hex Nuts (37).
Tighten into position.
6. Place a Wheel (2) between each bracket while
threading the Wheel Axle (1) through the axle
holes. Fit a Circlip (41) to each end of the
shaft.
7. Fasten a Handle Bracket (31) onto the front of
the bandsaw using M6 x 12mm Hex Bolts (36),
Flat Washers (39), Spring Washers (38) and
M6 Hex Nuts (37), as shown. Fit the remaining
bracket to the flange on the underside of the
bandsaw.