Ibiza sound UHF10A/B Manual De Instrucciones página 5

2. Antenna: Keep the position of the antenna at an angle of 45°
from vertical.
3. Audio connection: Connect the corresponding output
of the receiver via the supplied lead or an XLR lead to the
input of a power amplifier, mixer, etc.
TIPS TO ACHIEVE MAXIMUM PERFORMANCE
Make sure you can always see the receiver antenna from the transmitter position.
Keep the distance from transmitter to receiver antenna as short as possible.
Point the receiver antennas away from each other at a 45° angle from vertical.
Avoid placing the receiver antennae near metal surfaces and obstruction.
Monitor battery power and replace the battery as soon as the red light goes on.
If stacking or rack mounting receivers in a multiple system, do not allow antennae to touch or cross.
Perform a walk-through before performance or presentation. If dead spots are found, adjust location of the receiver.
If dead spots remain, mark them and avoid them during performance.
TROUBLESHOOTING
Problem
No sound
No sound
No sound
No sound
No sound
Distortion level increases
gradually
Indicator status
Red transmitter indicator doesn't
flash
Red indicator on transmitter is
flashing
The red POWER indicator on the
receiver is OFF
The signal indicators A/B on the
receiver are glowing
The signal indicators A/B on the
receiver are off. The POWER
indicators on the transmitter and
receiver are glowing
The signal indicators A/B on the
receiver and LOW BATTERY
indicator on the transmitter are
glowing
Solution
Slide the POWER ON/OFF switch on the transmitter
to ON. Make sure that the batteries are properly
inserted with the correct polarity (+/-). If the
batteries are correctly inserted, replace them by new
ones.
Slide the MUTE switch on the transmitter to ON
Check if the mains adaptor is plugged correctly into
the mains outlet and the DC socket. Make sure that
the mains outlet supplies the proper voltage
Increase the volume on the receiver. Check the
output connections from the receiver to the external
equipment
Make sure that the frequencies of the receiver and
the transmitter match.
Move the transmitter closer to the receiver
Replace transmitter battery