Idiomas disponibles
Idiomas disponibles
1minute until any residual
liquid evaporates.
9. Grind-in the teeth based
on the vertical dimension
available. Then, set the teeth
onto the baseplate using
Eclipse Set-Up Resin. If
more than 1.5 mm of tooth
structure is removed from the
ridgelap of any tooth after
bonding agent application,
the bonding agent should be
reapplied. Contour as usual.
Note: Any film remaining on
the tooth surface from the
bonding agent should be
removed with a carver.
10. Process the Eclipse
Prosthetic Resin according to
the Directions for Use.
Step-by-Step Instructions for
Tooth Adjustments
1.
If teeth must be repositioned
in the lab after the try-in visit,
this is best accomplished by
keeping the uncured denture
cool and breaking the teeth
away from the uncured resin.
Refrigerating the denture for
a short time will make this
easier. Also, using a sharp
instrument, such as a knife,
will promote clean extraction
of the tooth.
2. After removal, a tooth can
then be reset with a melt
interface of the denture
resins using a small amount
of additional Eclipse Set-Up
and Contour Resin.
3. Check uncured denture for
tight tooth-to-base margins.
4. Remove model from
articulated mounting,
preheat the denture and
cure the denture in an Eclipse
Processing Unit according
to Eclipse Prosthetic Resin
Directions for Use.
IMPORTANT HOT PLATE
INFORMATION
1.
All inquiries regarding hot
plates including repair,
service, warranty or reorders,
should be placed directly
with VWR International
at www.vwrsp.com or
1-800-932-5000. Specify
VWR part number 97042-578
or 12365-450 (digital 120 volt
model) or VWR part number
97042-580 or 12365-458
(230 volt model).
2. The metal ring attachment
on the hot plate is not
available through VWR. If
you need to send the hot
plate to VWR for any reason,
please remove the metal
ring from the hot plate. If a
new hot plate is sent to you,
reattach the metal ring to
the new hot plate. Contact
Dentsply Sirona for questions
regarding this attachment.
4
