Material Supplied; Installation Dimensions - Whirlpool AKR 860 IX Manual De Uso

MATERIAL SUPPLIED

Remove all the components from the packets. Check that all the components are included.
• Hood assembled with motor, lamps and grease filters installed.
• Instructions for assembly and use
• multi-connection flange ø150/125-120
• 4 screw caps
• exhaust pipe connector ø150
• 4 screws 4x12
• 4 screws 4 x16
• 2 screws 3.5x9.5
INSTALLATION - PRELIMINARY ASSEMBLY INSTRUCTIONS
The hood is designed for installation and use in "Extractor version" or in "Filter version".
Extractor Version
Fumes are extracted and expelled to the outside through an exhaust pipe (not supplied) fixed to the hood exhaust pipe connector
Depending on the exhaust pipe purchased, provide for suitable fixing to the exhaust pipe connector
IMPORTANT: If already installed, remove the carbon filter/s.
Filter Version
Air is filtered through the carbon filter/s and recycled into the surrounding environment.
IMPORTANT: Check that air recirculation is ensured.
If the hood does not have the carbon filter/s, order one/them and fit before use.
Install the hood away from very dirty areas, windows, doors and heat sources.
The hood comes with all the materials necessary for installation on the majority of walls/ceilings. However, a qualified technician must ensure that the materials
are suitable according to the type of wall/ceiling.

INSTALLATION DIMENSIONS

Wall unit interior 600 mm min.
Wall unit interior 900 mm min.
Adjacent wall units
centre line
65 cm (gas or combi cookers)
50 cm (electric cookers)
This type of hood must be installed inside a wall unit or similar support.
Adjacent wall units
hob surface
GB12