Genius Audio GTM-80.4D Manual Del Usuario página 12

CAUTION:
Be prepared to turn off the alarm on your vehicle and for
enter the unit code player radio.
AMPLIFIER GLOSSARY TECHNICAL AND FUNCTIONS
GTM-80.4D / GTM-100.4D
1. "Front" RCA INPUT
Use high quality stereo RCA Genius cables, connect the signal from the audio player to the RCA inputs of the
amplifier.
2. "Front and Rear" GAIN LEVEL
Adjust the sensitivity level "preamplifier" amplifiers. The minimum sensitivity level is 0.2V, while the highest
level is 5V.
3. "Front and Rear" High Pass Crossover
Adjust settings of the frequency of High Pass Crossover. The adjustable frequency range is 50Hz-2Khz. The
lower the setting, filtered frequencies in the audio signal. (All frequency which lies below the adjustment will be
filtered). All audio signals that are above the set level pass to 20kHz.
4. "Front and Rear" Low Pass Crossover
Adjust the frequency setting Low Pass Crossover. The adjustable frequency range is 50Hz-500Hz. The higher
the setting, filtered frequencies in the audio signal. (All frequency that are above adjustment will be filtered). All
audio signals which lies below the set level pass to 20Hz.
5. "Front and Rear" Crossover SWITCH
Activate the crossing "High Pass", "Low Pass" or FLAT (Full) Crossover.
6. "Front and Rear" BASS
Boost control low frequency adjustable from 0 db to 15 db
7. "Rear" RCA INPUT
Use high quality stereo RCA Genius cables, connect the signal from the audio player to the RCA inputs of the
amplifier
8. POWER LED light
When the amplifier is switched on and in operating condition, this LED will light blue.
9. PROTECTION LED light
If the active amplifier protection mode, this LED will light red.
10. Power Input
Feed B (+) and the pole to ground (GND) use 4 AWG while the remote uses an entry-gauge 12 AWG (REM
terminal is used to turn on and off remotely the amplifier when applied to + 12V )
11. Speakers Input
The speaker terminals are nickel plated allowing connection cables maximum size 10 AWG feeding the horn.
NOTE: The configuration of each channel must be verified by qualified personnel.
GT TECHNOLOGY
- 12 -