Triton 2000 Serie Instrucciones De Funcionamiento página 58

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 45
Fitting the Triton 235mm Precision Power Saw
FITTING THE SLIDE CHASSIS
Place the Slide Chassis (L) in the
bearing channels with the red plastic
catch and red bearing spacers closest
to the front panel (the switch box end)
and the flanges upwards. Enter two
bearings in the channel cutouts.
Slide the chassis towards the rear panel
and the other bearings will drop in.
Spray the channels with RP7 or WD40 for a smooth slide.
FITTING THE TRITON SAW
Unplug your saw. Check that the blade is set at 0˚ and
at full depth of cut.
Fit the Saw Alignment Cams (o) from below
the bases in the rectangular slots while you screw into
them. (They cut their own thread.) Make sure the lines
moulded on top of the cams are both pointing towards
the rear panel. Tighten the screws until nipped gently.
FITTING THE SAW LOCATORS AND KNOBS
Fit the saw into the chassis with the alignment cams
locating in the holes in the saw base-plate.
If the saw is set at full depth, the saw's spring-loaded
guard will be held in the retracted position by the back
edge of the chassis cutout.
Break or cut the Saw Locators (k) and Knobs (l) from their
moulding "tree" and carefully trim off any remnants with a
sharp knife. Fit the saw locators in the slots shown in
4 Philips-head screws (m) and Flange nuts (n). The straight
edges should be against the baseplate, but spaced away
from it slightly to allow for final saw adjustment. (Use a
spatula blade
6
or a piece of cardboard or metal about 1
mm thick as a spacer.) Firmly tighten the screws.
Screw the knobs on (they cut their own thread) until they just
scrape against the top edge of the saw base-plate.
tension is sufficient to hold the saw upside-down for final
adjustment, and still allow the saw to be shifted sideways
slightly using the alignment cams.
Check that the saw is securely mounted. Turn the slide
chassis over, re-engaging the bearings in the channels.
Page 4
For other brands of saw go to Page 6.
1
2
, holding
3
1
4
5
using
7
This
8
&
9
3
6
8
2
4
5
7
9
Tabla de contenido
loading

Este manual también es adecuado para:

Wca201

Tabla de contenido