Preparation; Checking The Contents Of The Package; Names And Functions Of Parts; Front Side - Fujitsu ScanSnap fi-5110EOX Manual Del Operador

Ocultar thumbs Ver también para ScanSnap fi-5110EOX:
Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

1. Preparation

This chapter describes necessary preparations before using
ScanSnap.
Do not connect the scanner to your PC
ATTENTION
before installing "ScanSnap Manager".
If the scanner is connected before installing
ScanSnap Manager, it will not operate
correctly.
Refer to Chapter 2 for the installation of
ScanSnap Manager.
1.1. Checking the Contents of the
Package
When you unpack the scanner package, make sure that all
parts are included.
Refer to the package contents list included the scanner
package box.

1.2. Names and Functions of Parts

This section describes the names and functions of parts.

Front Side

Paper chute cover
Open this cover when using
the scanner.
→ Opening the cover turns
ON the scanner.
ADF cover
(ADF: Automatic Document Feeder)
Stacker
Place the scanner aligning
the two front projection to
the hollows on the bottom
of the scanner.
Cover open lever
Pull this lever to open the ADF
Paper chute cover
Open this cover and load the
documents onto this part when
scanning documents.
Side guide
Adjust these guides to the
documents width for
preventing skewed
images.
Stacker
For using this part, pull it out
as shown in the figure.
→ Documents are ejected from the ADF onto this tray.
* You can also use the scanner without the Stacker.
cover.
Buttons
Buttons

Rear Side

USB connector
Seal: After installing ScanSnap Manager onto
your computer, remove this seal to connect the
scanner to the PC.
For the Document Specification, refer to the
HINT
"ScanSnap fi-5110EOX Operator's Guide"
stored in ScanSnap Setup CD-ROM.
The scanner is turned on/off automatically, when
ATTENTION
you open/close the Paper chute cover.
To turn off the scanner when the cover is opened,
press the [POWER] button.
ScanSnap fi-5110EOX Getting Started | 5
[SCAN] button
Starts scanning.
[POWER] button
Turns on/off the power supply.
Power lamp
Indicates the scanner status.
Green
:Ready
Green (Blinking) :Scanning
Orange
:Error
Light off
:Power off
AC adapter connector
Tabla de contenido

Solución de problemas

loading

Tabla de contenido