Idiomas disponibles
Idiomas disponibles
Assembly
The Marten-/Cat-Free-Device is fastened by means of self-tapping screws or binders in
the engine compartment on the carriage. The connecting cable to the car battery must
be passed in that manner that it doesn't get in contact with movable or hot parts (e.g.
ventilating wheel, exhaust manifold). The device should be placed in the engine
compartment in that manner that the acoustic noise can constantly spread and is not
absorbed by insulating mats.
ATTENTION: The assembly should be carried out by authorised specialised staff!
Electrical connection
The device is directly connected to the car battery. The red cable is connected to the
positive pole, the black one to the negative pole. If additionally the black cable is
connected to clamp 15 alternatively (ignition lock, car radio) of the car battery, the control
automatically switches on the device, when the ignition is turned off and automatically
switches it off, when the ignition is switched on. This increases the durability of the
device, as it is only put into operation with the motor turned off.
The device is fitted with an automatic shutdown when the car battery reaches a voltage
of less than about 11 volts. This prevents deep discharge by the device. When this "Car-
Battery-Control" (CPC) is activated, the device is deactivated and the load on the car
battery is reduced. When the battery voltage (by battery replacement or recharging)
increases to about 11 volts or higher, the device is switched on in active mode again.
NOTICE: If you do not intend to use your car for some time, please disconnect
your Marten-/Cat-Free to preserve the battery
Important Note! Electrical connection by CAN/BUS system: Vehicles with
CAN/BUS system should be connected to the black wire with the fuse of terminal
15.
General information
1. Electric appliances, packaging material etc. should be kept away from children.
2. Dispose packaging and worn out material correctly and in an environmentally friendly
way.
3. Do only pass on the device including the operation manual.
4. Subject to change of design and technical data without notice for the sake of constant
product improvement.
General notes
When your car has already been visited by martens, most likely the animals left their
marks for the identification of their area. These odours must unconditionally be removed
before the assembly of the Marten-/Cat-Free-Device, as other martens could possibly
enter even to a bite protected engine compartment. The best way to do so is by means
of an efficient motor wash. Furthermore, the animals leave their marks frequently under
the vehicle, e.g. on the car park. It is therefore recommendable to remove these traces
with detergents and mop in order not to give any reasons to the marten to be forced to
defend its area.
