Normal Use - AUSTRIALPIN Universal Junior Manual De Instrucciones

the highest level of protection if this adjustment
is done correctly. A perfect and safe adjustment
on the head is guaranteed only if the chin strap
is locked and tightened and with a correct
adjustment to the cranial perimeter. The straps
must not cover the ears and the buckle must not
touch the chin. The locked chin strap must not
exert pressure on the larynx. The helmet must
be adjusted on the head always in a horizontal
position so that it protects the forehead as well.
Wear the helmet with the back size adjust
system open
1. Lock the size adjust system by rotating
the back wheel
2. Lock the chin strap buckle. A locking
"click" must be heard. Tighten the strap so
that the buckle is properly locked
3. Adjust the chin strap
4. Check the correct position of the helmet
and the correct locking of the systems
(buckle and back size adjust system). If
the helmet is worn correctly, it must not
move or rock side to side. The better the
helmet adjustment, the higher the level of
safety.
Check before use
Before use, check the state of the shell and
harness system, check the state of the chin
strap and stitching. Check if the size adjustment
system and chin strap buckle work properly.
Changes to original components
The possible change or removal of original
components of the product can limit its safety
features. It is highly recommended that no
modifications or adjustments are made to the
equipment to add further components unless
explicitly advised so by the manufacturer in
writing. Apply colours, solvents, glue or sticky
labels only if they comply with the information
provided by the manufacturer.
Warning! The products must not
8
be exposed to dangerous conditions and
improper treatments.
Avoid contact with corrosive or aggressive
substances (such as: acids, bases, flux for
welding, oils, detergents). Avoid exposure to
high temperatures, for instance by leaving the
helmet inside a vehicle exposed to sunlight.
Avoid contact with heat or sparks. Do not sit on
the helmet and do not compress the helmet in
a sack. Avoid contact with sharp objects. Avoid
letting the helmet fall.
Temperature of use
The product (dry
permanently in the temperature range of -20°C
to +35°C.
Duration and replacement
The duration of the product depends on the
typology and frequency of use and well as on
external factors. Although not used, the helmet
is subject to ageing due to the intensity of UV
rays and weather conditions.

Normal use

Duration in case of normal and proper use,
without evident wear marks and under optimal
storage conditions:
duration of the product under optimal
storage conditions and if not used: 10 years.
Very frequent use or under
extreme conditions
If the product is used under extreme conditions,
very high or very low temperatures, sea water,
or if exposed to frequent blows and shocks
due to the fall of stones/ice and if it presents
many scratches, its safety features could be
reduced even after a brief period of use so that
the product should be replaced. This helmet is
designed to absorb the energy after an impact.
The absorption of the blow occurs through the
partial breaking or damaging of the shell or
state) may be
5 years. Maximum
used