Technical Data - DAY Useful Everyday 73439 Manual De Instrucciones

SOAP DISPENSER
Introduction
To get the most out of your new soap
dispenser, please read through these
instructions before use. Please also save the
instructions in case you need to refer to them
at a later date.

Technical data

Power supply:
Capacity:
With infrared sensor and foam function
Class III: Protection against electric
III
shock is achieved because the item
is only supplied with extra-low
voltage and the item itself does
not generate a higher voltage than
extra-low voltage.
10
4×1.5 V AA batteries
(not included)
300 ml
Use
Carefully unpack the soap dispenser.
Open the battery cover on the base of the
soap dispenser by turning it anticlockwise
and insert 4 x 1.5 V AA batteries. Insert the
batteries in the battery compartment as
indicated.
Replace the batter cover so that the arrows
are lined up. Turn the battery cover clockwise
until it locks into place.
Stand the soap dispenser upright and
remove the silicon plug from the refi lling
opening.
Foam is produced with 1/3 soap and 2/3
water.
Do not fi ll the container with soaps that
contain solid particles, as these may damage
the soap dispenser.
Replace the upper section again.
Switch the soap dispenser on using the
on/off button at the top.
The soap dispenser is now ready for use.
When you want soap, simply place your
hands under the soap dispenser's nozzle and
wait until the soap foam is dispensed.