Set Time And Date - ICC RONER TOUCH Serie Manual De Instrucciones

INSTRUCTION MANUAL
IDIOMA FECHA/HORA
INTRODUCIR
BRILLO
CONTRASEÑA
INFO
DESC. REG.
Fig 7.2 Programming screen
J
.P. SELECTA s.a.u.
CODE 80301 REV A
7.2 Settings screen
UNIDADES

7.2.1 Set time and date:

CAMBIAR CON-
Press on Date/time button. Press over push buttons to set time and date.
TRASEÑA
Use Up and Down icons to entry a value.
7.2.2 Set temperature, language and screen contrast
CAL
In a similar way set the temperature units, the language and the screen contrast.
7.2.2 Working parameters protected under password
There are several parameters under password "0000" which affect the equipment
operation.
a) Log interval
b) Calibration (OFFSET)
cated by the equipment and the one indicated by a standard thermometer.
Enter a value of -0.5ºC to correct the deviation.
c) The lower and the upper limit of temperature
This allows you to adjust the working temperature range of the equipment.
7.3
Up to 10 programs of temperature and time can be created.
Each program has the following parameters:
Temperature:
Time:
Undertemp:
Overtemp:
*A warning message appears.
Autovía A-2 Km 585.1 Abrera 08630 (Barcelona) España
e-mail: [email protected] - website: http://www.jpselecta.es
Sep/2016
password:
log interval:
calibration:
lower temp. limit:
upper temp. limit:
It is the frequency of data collection for logging.
Use only this setting if you notice a deviation between the temperature indi-
For example: the equipment indicates 40.0ºC, the pattern indicates 40.5ºC.
These are the maximum and the minimum limits of temperature adjustments.
Temperature and working time setting
Temperature: from ambient+5ºC ... 200ºC
HH:MM
Alarm value for temperature drop.*
Alarm value for overtemperature.*
(It can be modifi ed without notice)
0000
1 to 60min
-100 to +100
-10
-10
Tel 34 937 700 877 Fax 34 937 702 362
Page: 14